IS series single-stage end-suction(axial intake) cetrifugal pump is an energy-saving pump designed by teamwork in the whole nation, it is improved on basis on model BA, B and other single-stage water centrifugal pump. The advantages： its hydraulic capability is distributed reasonably, wide option for user, conveniently check and repair, the efliciency and throw is up to advanced international level. This pump is suitable for industrial and city water supply, water drainage, and widely used for agricultural irrigation, transportation pure water or other liquids which physical and chemical nature is similar to pure water, and the temperature should not be higher than 80*0.

STRUCTURE DIRECTIONS

1. IS series single-stage end-suction centrifugal pump is designed according to the capability and size stipulated in the international Standard ISO2858, it is composed of pump body, pump cover impeller, shaft, ring seal, sleeve and suspended bearing units.

2. The pump body and pump cover in IS series are separaled from the back of impeller, that is to say in general, back open structure, whose advantages: convenient overhaul, when checking and repairing, the pump body intake pipe, discharge pipe and motor need not to move, just disassemly the middle connector of extended coupling to quit therotor units for overhaul.

3. The pump shell (that is pump body and pump cover) forms the workroom of pump, impeller, shaft and rolling bearing are the rotors for the pump. Suspended bearing units support the rotors in lhe pump. The rolling bearing stands the radial load and axial force.

4. The axial sealing ring of the pump is composed of packing gland, packing rings and packing to avoid air admission or severe water leakage. For the impeller with balance hole, the empty chamber wilh soft packing is straight through with the impeller inlet. If the liquid in the impeller inlet is in vacuum state, the air will enter along the surface of muff easily. Therefore, the packing chamber is fitted with packing ring, which has the seal funclion when pressure watter inside the chamber is led to it through a small hole in the pump cover. For the impeller without balance hole, the packing ring may be neglected in virtue of no existence of air leakage because the impeller back hydraulic pressure is larger than atmosphere one.

5. To avoid abrasion of shaft, the part where the shaft runs through packing chamber is fitted with protective muff. O ring is fitted between muff and shaft to protect against air entering or water leaking along the matching surface.

6. The pump is connected to motor with extending flexible coupling. The pump turns clockwise when you look from the driving end.

IS Series Clear Water Pump Pump parameters:

Range：

Discharge Size：32 – 150 mm

Capacity：3 – 450 m ³ /h

Head：5 – 125 m

As a Centrifugal Clear Water Pump Supplier, we supply all kinds of Clear Water Pump Pumps like Self Priming Dirty Water Pumps,Potable & Clean Water Pumps and so on.

MODEL DEFINITION

STRUCTURAL DIAGRAM

CURVE DIAGRAM

APPLICATIONS

Industry & City Water Supply and Drainage, Landscape Irrigation, WXB, Long-Distance Transportation, Farm Irrigation, Refrigerating Cycle, Chemical Plant, Mining

FEATURES

1.Vertical structure, which can greatly save the space in special occasions.

2.Good quality and low cost. Due to high efficiency and low power, the cost is greatly reduced.

3.Low maintenance cost, as long as a simple replacement of a set of blade or bearing. It has the features of simple structure and convenient replacement.

4.Adopting advanced hydraulic model, it has high efficiency and good performance.

5.Adopting high quality mechanical seal, the moving and static ring is made of cemented carbide, with no leakage and long service life.